Part 1 FCC Notes: This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in acco
Part 10 CONNECTING CABLES To connect all required cables to the appropriate connectors please make sure that each connector is connected to the corr
Part 11 USING THE TOUCH TERMINAL APPLICATION ENVIRONMENT It is very important to check the following operational guidelines: Ventilation This term
Part 12 disabled or when pop up warning message like this picture appears, please replace the used up UPS battery at power off as soon as
Part 13 Hardware Power Switch The power switch located in the touch open front door of the main unit is a tactile pushbutton switch. Th
Part 14 “Power Management Setup” to prepare the system ready to respond to a COM port MODEM Ring or wake up call from an operating caller system con
Part 15 the card is a standard one. A non-standard card recorded without complete degaussing prior to recovery may accept only one direct
Part 16 Emergency Power Off In case of serious system halt due to any reason, the system could fail to be powered off through normal mean
Part 2 ALERT TO OUR HONORABLE CUSTOMERS: Please always read thoroughly all the instructions and documents delivered with the product
Part 3 INTRODUCTION PRODUCT PICTURES Front View Inside Front Door Left Side View Rear Top View II Rear View Bottom View 14
Part 4 PARTS IDENTIFICATION 1. Display unit 2. Keyboard area (stroke type in the picture) 3. Front Cover 4. Power indicator 5. USB Port 6. Pow
Part 5 side) 5. one UPS battery connector 6. one DC 12 V power input connector Support DDR3 SDRAM with maximum memory size 4GB in one SO-DIMM mo
Part 6 INSTALLATION GUIDES CAUTION: Before any installation or cable connection to the set, please always make certain that the system
Part 7 INSTALLING PD-201 (OPTION) Please first have an authorized technician to open the jumper setting service window on the bottom and set a DC
Part 8 in the right picture. Please pull the cables gently while installing the PD-201 + UPS battery cover assembly back onto the system top
Part 9 the tab in guiding hole and gently press the key top down till a click sound is heard as indicated in the pictures below. Failur
Kommentare zu diesen Handbüchern